Handling Of Common Problems Of Flat Screen Printer Factory

The occurrence of this phenomenon in the Open Type Rotary Screen Printing Machine is that the proximity switch at the upper left of the vertical slide is not sensed or there is a problem with the proximity switch. Solution: Adjust the proximity sensor or proximity switch above.

    The open rotary screen printing machine is a machine that prints text and images, and often shows various machine problems during work. As a printing staff, we must be familiar with the following reasons and treatment methods for electromechanical equipment to make the printing process. Stopped smoothly. The following are some common problems and treatment methods of Licheng Flat Screen Printer Factory.

    The first phenomenon of the open rotary screen printing machine: when it is semi-automatic, it does not step on the foot switch and acts immediately. This kind of fault is mostly caused by the damage of the foot switch or the short circuit of the foot switch socket causing a short circuit, and the other is the problem of the manual start button switch. Remedy: Replace with new switches, sockets, button switches, or disassemble and repair related damaged parts.


    The second phenomenon of the open-type rotary screen printing machine: when the semi-automatic work is performed, the foot switch slides down and then rises after being released. This phenomenon is usually caused by the proximity switch on the left side of the slide seat being damaged or disconnected. Solution: Change the proximity switch or connect the switch wiring. The third phenomenon of the open rotary screen printing machine: when the semi-automatic work is performed, the vertical slide seat is stepped on by stepping on the foot switch, and the printing seat does not move after moving to the left. This problem occurs because the proximity switch on the left side of the horizontal slide is not sensed or is defective. Also, the micro switch in the foot switch is stuck and does not move, which will also cause this problem.


Solution: Adjust the left proximity switch induction point or replace the proximity switch, and adjust, repair or replace the micro switch in the foot switch. The fourth phenomenon of the open-type rotary screen printing machine: stepping on the foot switch during semi-automatic operation, the slider descends to the left and then rises but does not move to the right. The occurrence of this phenomenon in the Open Type Rotary Screen Printing Machine is that the proximity switch at the upper left of the vertical slide is not sensed or there is a problem with the proximity switch. Solution: Adjust the proximity sensor or proximity switch above.


flatprinter flatprinter

1 مدونة المشاركات

التعليقات